FujiFilm A203 - Manual (Page 9)

17
1
16
SETTING THE DATE AND TIME
Changing the date and time
To change the date and time:
1 Press the “MENU/OK” button.
2 Use “d” or “c” to select “
g ” OPTION and
then use “a” or “b” to select “SET–UP”.
3 Press the “MENU/OK” button.
4 Select “DATE/TIME” and press “c”.
See P.14, 15 for information on setting the date
and time.
0 1 0 3 0 2 0 4
◆
Power Save Function
◆
If the camera is not used for 2 minutes, this
function automatically switches the camera off.
When this function is active, it also switches off
the LCD monitor to reduce power consumption if
the camera is not used for 30 seconds (See
P.74 for details).
◆
Checking the remaining battery charge
◆
Switch the camera on and check that no battery
level warning (
Z or X ) is displayed on the
LCD monitor. If no icon is displayed, there is
ample charge left in the battery.
i Z Lit red:
The battery is low on charge. Have a new
battery ready.
i X Blinking red:
The battery is exhausted. The display will shortly
go blank and the camera will stop working.
Replace or recharge the battery.
● ! The above estimates are for the Still photography
modes. In Playback mode, the transition from
“Z” to “X” may take less time.
0 1 0 2
1Press “d” or “c” to select the date format.
2Press “a” or “b” to set the format. Refer to
the table below for details of the settings.
You can select your preferred date format.
To change the date display format
Displays the date in the “month/day/
year” format.
MM/DD/YYYY
Displays the date in the “day.month.
year” format.
DD.MM.YYYY
YYYY.MM.DD
Explanation Setting
Displays the date in the “year.month.
day” format.