Fisher-Price K9125 - Manual (Page 4)

4
Assembly Assembly
Side Edg
e
4
3
1 2
Proper label application will help to keep the label looking its best!
• Make sure the area where the label will be applied is clean and dry. Wipe
the backboard with a clean, soft, dry cloth to remove any dust or oils.
• For best results, avoid applying the label more than once.
• Peel the backing from one half of the label. Do not remove all of the backing!
• Align the side edge of label 1 (where backing is removed) with the side edge
of the label area on the backboard.
• Carefully apply the side edge of the label to the side edge of the label area
on the backboard.
• While rubbing the label in place, continue to peel the backing from the
other half of the label.
• Apply the remaining labels to the backboard. Labels 1 - 4 are designed
to overlap.
• Dispose of the label backing properly.
7
1
5
6
• Bend the “T” end of the plug and insert it into the hole in the base.
Note: After assembly is complete, fi ll the base with water or approximately
50 lbs. (22.7 kg) of sand (water and sand not included) to keep this product
stationary. Simply lift the plug, fi ll the base, and replace the plug.
Plug “T” End Base
• Position the base as shown.
• Position the upper post so that the straight end is down and the curved end
is up and facing away from the base.
Hint: For easier assembly, apply liquid soap or rub a candle or bar soap
around the bottom of the upper post (especially on the corners) and the inside
of the large square opening. If assembling inside, place a tarp under the base
to protect the fl oor surface.
• Insert the upper post into the large square opening in the base and, using a
circular motion, push it all the way down.
4
5
6
Large Square Opening
Base
Upper Post
Curved End
2
3
• Hook the rectangular tab on each side of the rim to the upper post,
as shown.
• Rotate the rim down until it snaps into place on the upper post. Push down
on the rim to be sure it is secure.
4
5
6
Rectangular Tab
Rim
Upper Post
4