Follett HCC1400W - Manual (Page 6)

6
Dimensions and clearances
Entire front of icemaker must be clear of obstructions/connections to allow removal.
1" (26mm) clearance above icemaker for service.
1" (26mm) minimum clearance on sides.
The intake and exhaust air grilles must provide at least 170 sq in (968 sq cm) of open area.
Air-cooled model HCC1400A icemakers – 18" (458mm) minimum clearance between discharge and air
intake-grilles.
C
MOTOR COMPRESSOR THERMALLY PROTECTED
MIN. BRANCH CIRCUIT AMPACITY MAX. BRANCH CIRCUIT FUSE SIZE
DESIGN PRESSURE HIGH SIDE
Stock Module Identification Plate FULL LOAD AMPS
REFRIGERANT Module No. Product Service No.
MODEL CORPORATION SERIAL NO
VOLTS
AMPS AMPS
208264
Easton Pennsylvania
HZ
R R
PART NO
CHARGE LOW SIDE
SINGLE
PHASE
OZ
MADE IN
THE USA PSIG
NEMA 6-20
right angle
G
Air intake
23.50"
(597mm)
2.72"
(69mm)
23.8" (580mm)
21.05" (535mm)
Air exhaust
both sides
3/8" OD push-in water inlet
3/4" MPT drain
Air exhaust
15.56"
(395mm)
6.97"
(177mm)
2.53"
(64mm)
2.43" (62mm)
29.63" (753mm)
L U L U NSF
21.28" (541mm)
Front View Side View Back View
Ice transport hose connection
1/4" FPT
condenser inlet
1/4" FPT
condenser drain