Follett T400A/W - Manual (Page 15)

15
1" (25mm)
ice tube
retaining
bracket
ice tube ice tube
Ice tube retainer bracket
Front View, VU155 Front View, VU300
thermostat thermostat
thermostat
ice tube
retaining
bracket
ice tube
retaining
bracket
ice tube
ice tube tabs in ice tube
retainer bracket
engage holes in ice
tube and hold tube
in place
Bin thermostat capillary tube mounting
Additional ice transport tube connection specifications for Vision series ice and beverage dispensers
Check to make sure bin signal on icemaker control board is switched to 24 volt connection.
1. Push one end of ice transport tube(s) through hole(s) provided in side of dispenser.
2. Route tube into ice tube bracket inside dispenser and engage bracket tabs in holes located in end of ice
transport tube(s) (see drawings below).
3. Verify bin thermostat capillary tube is mounted correctly (see drawings below).