FieldServer FS-8700-114 X30 - Manual (Page 11)

FS-8700-114 DeviceNet Master Manual Page 11 of 13
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix C.2. Using the Command and Status Data Arrays
The Command Data Array controls the Scanner’s mode which can be either Run or Idle. The Scanner can only be
configured when in Idle mode. A non-zero value at offset zero in the Command Data Array will place the Scanner
in Run mode; a value of zero will place it in Idle mode. The Scanner always powers up in Idle mode and can be set
to Run mode automatically with a preload section or from the Server side protocol of the FieldServer. The
following preload section can be placed in the configuration file to place the scanner in Run mode at power-up:
Preloads
Data_Array_Name , Preload_Data_Format , Preload_Data_Value , Location
Command_Reg
, Bit , 1 , 0
Offset zero of the Status Data Array indicates the Scanner’s actual mode achieved. A non-zero value indicates the
Scanner is in Run mode and a value of zero indicates the scanner is in Idle mode.
Appendix C.3. Master Status Codes
The Master Status codes displayed on the F-screen are depicted below: