Fire Magic ECHELON E660 - Manual (Page 37)

37
8. Replace the orifi ce using a 3 /
8
" hex nut driver.
Note: It will help to start the brass orifi ce with
your fi ngers to avoid cross threading it.
9. Replace each brass burner by bending the
connected metal tubing back into place so that
the threaded top of the burner sticks through
from underneath the burner hole and screw it
in using the brass nut and the
15
/
16
" wrench.
Important: Do not over tighten.
10. Fo l l ow s t e p s 5 a n d 6 u n d e r O R I F I C E
CHECKING.
ADJUSTING THE FLAME
Height of the fl ame with a valve in low position
may be further regulated by means of a small
adjusting screw in the center of the valve stem. This
screw is accessible by removing the valve knob
which pulls straight off the end of the valve stem.
Turn the screw to the right to reduce the fl ame
height at the low setting and to the left to increase
it.
Note: The double sideburner has no air-shutter
adjustment.
DOUBLE SIDEBURNER