FUJITSU MAS3367FC - Manual (Page 63)

C141-E198 5-1
CHAPTER 5 Installation
5.1 Notes on Handling Drives
5.2 Setting
5.3 Mounting Drives
5.4 Dismounting Drives
5.5 Checking Operation after Installation and Preparing
the IDD for Use
5.6 Spare Disk Drive
This chapter describes the notes on handling drives, setting, mounting drives, confirming drive operations
after installation and preparation for use, and dismounting drives.
5.1
Notes on Handling Drives
The items listed in the specifications in Table 2.1 must be strictly observed.
(1) General
notes
a) Do not give the drive shocks or vibrations exceeding the value defined in the standard because it
may cause critical damage to the drive. Especially be careful when unpacking.
b) Do not leave the drive in a dirty or contaminated environment.
c) Since static discharge may destroy the CMOS semiconductors in the drive, note the following
after unpacking:
•
Use an antistatic mat and body grounding when handling the drive.
•
Hold the DE when handling the drive. Do not touch PCAs except for setting.
Hot temperature
To prevent injury, do not handle the drive until after the device has
cooled sufficiently after turning off the power. The DE and LSI become
hot during operation and remain hot immediately after turning off the
power.