FRIGIDAIRE 137153700B - Manual (Page 12)

12
Door Reversal
Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
Open the dryer door. Remove the four hinge hole plugs from 1.
the left side of the door opening. Place nearby for future
installation.
1
2
3
4
Accessories
LP CONVERSION KIT
P/N PCK2003
Gas dryers intended for use in a location supplied with LP
must use a conversion kit prior to installation.
MOBILE HOME INSTALLATION KIT
P/N 137067200
Installations in mobile homes require use of MOBILE HOME
INSTALLATION KIT.
DRYING RACK
Depending on the model you purchased, a drying rack may
have been included in the initial purchase of your dryer.
If your model did not include a drying rack or you desire
another drying rack, you may order one from your local parts
distributor.
DIRECTIONAL VENTING KIT
P/N 131456800
Order this kit to utilize the side venting option of the dryer.
Additional hardware available from your local hardware store
will be necessary.
TOUCH UP PAINT PENS
White Touch Up Pen - P/N 5303321319
Bisque Touch Up Bottle - P/N 5304414035
Black Touch Up Pen - P/N 5304458932
UNDER-COUNTER INSTALLATION KIT
(front console model only)
For under-counter installation, top panel must be removed
and kit number 131629100 must be installed.
DRYER STACKING KIT
(front console model only)
P/N 5303937141
Depending on the model you purchased, a kit for stacking
this dryer on top of matching washer may have been
included in the initial purchase of your dryer. If your model
did not include a stacking kit or you desire another stacking
kit, you may order one.
15 INCH (38 cm) PEDESTAL
(front console model only)
A pedestal accessory, specifi cally designed for this dryer may
be used to elevate the dryer for ease of use. This pedestal will
add about 15” (38 cm) to the height of your unit for a total
height of 51.25” (130 cm). Contact the location where you
purchased your dryer.
Failure to use accessories manufactured by (or
approved by) the manufacturer could result in personal injury,
property damage or damage to the dryer.
Replacement parts:
If replacements parts are needed for your dryer, contact the
source where you purchased your dryer.
- ELECTRICAL SHOCK HAZARD - Label all
wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation. Verify
proper operation after servicing.
You may need a plastic knife to help pull out the
plugs. Be careful not to scratch the paint.
Remove the four screws that secure the door hinges to the 2.
dryer front panel (see below).
Rotate the door 180° and reinstall the door hinges to the 3.
dryer front panel with the four screws.
Install the four hinge hole plugs in the open screw holes on
4.
the opposite side of the door opening.