FRIGIDAIRE FSEC/FSGC748GF - Manual

OPERATING INSTRUCTIONS
" Cut along this edge to separate English from other languages. "
FSEC/FSGC748GF
FSE/FSG748GF
Before Operating Your Dryer
Read your dryer Owner's Guide. It has important
safety and warranty information. It also has many
suggestions for best drying results.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY
INSTRUCTIONS in your dryer Owner's Guide before
operating this appliance.
Operating Steps
Read Drying Procedures in your Owner's Guide. It
explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric
softener sheet.
4. Close the dryer door.
5. Set Dry Temperature and Cycle Signal controls.
6. Turn cycle selector clockwise to desired setting.
7. Start dryer. Turn the Turn to Start control clockwise
to ON. Hold for 1-2 seconds and release.
8. When Cycle Signal control is on, a signal will
sound at the end of the cycle.
9. Remove items immediately and hang or fold.
10. Clean lint screen after every load.
Temperature Selection
Always follow directions on fabric care labels.
To avoid fire hazard, do not use heat to
dry items containing feathers or down, foam rubber,
plastics, or similarly textured, rubber-like materials. Use
Air Fluff-No Heat setting only.
The REGULAR-HIGH HEAT, PERM PRESS-MEDIUM
HEAT, and KNITS/DELICATES-LOW HEAT temp-erature
settings may be used with any cycle setting. The AIR
FLUFF-NO HEAT setting can be used only in the Timed
Dry cycle.
AIR FLUFF-NO HEAT setting tumbles the load without
heat. Use Air Fluff to freshen clothing, pillows or blankets,
or to dust draperies.
Cycle Selection
Turn cycle selector clockwise to desired cycle and
setting.
Each cycle ends with a cool down period. The heat
automatically turns off and the load continues to tumble
during the cool down period. This reduces wrinkling and
makes items easier to handle during unloading.
Drying time varies depending on size and dampness of
load, weight and fabric type. Room temperature and
humidity, type of installation and electrical voltage or gas
pressure can also affect drying time.
Printed in U.S.A. P/N 131713000 (9803)
(continued, reverse side)
TIMED DRY
REGULAR
NORMAL DRY
NORMAL
DRY
NORMAL
DRY
TIMED DRY
REGULAR AUTOMATIC
DELICATE MOISTURE SENSOR
INTERIOR DRUM LIGHT
TIMED DRY
REGULAR
AUTOMATIC
DELICATE
AUTOMATIC
PERM PRESS
AUTOMATIC
REGULAR