FUJITSU P2U3-0022-04ENZ0 - Manual (Page 12)

Chapter 1 Installing ETERNUSmgr
>
1.6 Procedure
ETERNUS Disk storage systems ETERNUSmgr Install Guide for Linux
12
Copyright 2009 FUJITSU LIMITED
P2U3-0022-04ENZ0
1.6.1 Installation by rpm Command
Execute "./bin/linux/FJSVgrmgr-VxxLxx-1.i386rpm" (which is an install package included with the
CD-ROM), by abiding by the following format. Installation must be conducted by the superuser. If
the installation directory is not specified, ETERNUSmgr will be installed in "/opt/FJSVgrmgr/" as
default. Refer to the entering "rpm" command in step 2 in the following, for installation directory
specification procedures.
* VxxLxx refers to the version/level number.
Procedure
1
Login as the superuser, and go to the directory where the install package is
located.
2
Follow the above format and enter the "rpm" command.
• When installing ETERNUSmgr V20L30 to the "/opt/FJSVgrmgr/" default directory
(Example) # rpm -ivh FJSVgrmgr-V20L30-1.i386.rpm
When specifying the installation directory, use the following example as a reference to
execute the "rpm" command.
• When installing ETERNUSmgr V20L30 to the "/usr/share/" directory
(Example) # rpm -ivh --prefix /usr/share FJSVgrmgr-V20L30-1.i386.rpm
3
This complete the installation with the "rpm" command.
If installation completed normally, the following message will appear:
(message displayed)
# Install of FJSVgrmgr completed.
End of procedure
Setup the environment settings by executing the ETERNUSmgr environment setup script.
ETERNUSmgr cannot activate normally if the environment is not set.
1.6.2 ETERNUSmgr Environment Setup
After installation by "rpm" is complete, a file for ETERNUSmgr environment setup script with the
name "stxpollset.sh," will be created in the installation directory (default is "/opt/FJSVgrmgr").
Transfer "stxpollset.sh" to the installation directory, and then execute.
Executing "stxpollset.sh" must be conducted by the superuser.
From here on, input each type of parameter by interacting with ETERNUSmgr environment setup
script "stxpollset.sh".
Format:rpm -ivh FJSVgrmgr-V20L30-1.i386.rpm
Format:rpm -ivh --prefix "installation directory" FJSVgrmgr-V20L30-1.i386.rpm