Fisher-Price K4563 - Manual (Page 15)

28
Door
Hinge
Door
• Fit a door into the groove on the side of the dash.
Hint: Each door is designed to fit one way. If the door does not fit,
try the other door.
29
1
K9758pr-0920
• Fit a hinge over the top end of the door.
Hint: Each hinge is designed to fit one way. If the hinge does not fit,
try the other hinge.
• Insert three #10 x ¾" screws into the hinge and tighten.
• Repeat assembly steps 29 and 30 to assemble the other door
and hinge.
ASSEMBLY F
26
Taillight
Housing
Taillight
Lens
#8 x 1" Screws
• Turn the vehicle upright.
• Using safety scissors, remove the taillight lenses and the taillight
housings from the plastic connectors. Dispose of the plastic
connectors.
• Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
• Position the taillight housing with lens against the vehicle with the
screw holes aligned, as shown.
• Insert two #8 x 1" screws through the taillight lens, housing and into
the vehicle as shown. Tighten the screws.
• Repeat this procedure to attach the other taillight assembly.
27
• Position the cap so that the tether is down.
• Snap the cap into the hole under the right taillight.
Tether
Cap
BACK VIEW
SIDE VIEW