Fisher-Price K4563 - Manual (Page 12)

K9758pr-0920
1
ASSEMBLY F
K9758pr-0920
16
Spacers
• Fit two spacers between the upper holes of the brush guard and the
front end of the vehicle A .
• Insert two #8 x 4" screws through the upper holes in the brush guard,
through the spacers and into the front end of the vehicle B .
Tighten the screws.
Brush Guard
• Fit and hold the brush guard against the front end of the vehicle.
Hint: Using the end of a Phillips screwdriver, poke a hole in the thin,
plastic covering over the lower holes in the brush guard.
• Insert two #10 x ¾" screws through the
lower holes in the brush
guard and into the vehicle. Tighten the screws.
15
18
• Insert each fastener end of the long seat belt strap through a slot in
the center of the seat. Make sure the fasteners face the outer edge
of the seat.
• Pull each side of the long seat belt strap evenly through the slots.
Make sure to pull each T-loop through a slot.
• Turn the seat upright.
T-Loop
Fastener End
Long Seat Belt Strap
17
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through the slot
near the outer edge of the seat. Make sure the side of the seat belt
with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until the
last T-loop at the opposite end of the belt catches against the slot.
You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
Short Seat
Belt Strap
Fastener End
Seat
Slot
T-Loops
Slot
T-Loop (Pull through slot)
A
B
#8 x 4"
Screws