FUJITSU fi-5220C - Manual (Page 14)

6
4. Insert the Setup CD-ROM into the CD drive.
⇒
appears.
5. Click [INSTALL PRODUCTS].
6. Click [TWAIN Driver] on the window below.
7. Error Recovery Guide Installation window
appears.
Error Recovery Guide is a software that dis-
plays troubleshooting information on screen
when any scanner error occurs, and its installa-
tion is highly recommended. However, it can
be installed later if you do not install it in this
step.
8. Select a language used for installation on
[Choose Setup Language] window and click
[OK].
9. Install the application following the instructions
on the window.
10. When the [InstallShield Wiizard Complete] win-
dow appears, click [Finish].
Your computer will be restarted and the scanner will be
detected. Do not remove the Setup CD-ROM from the
CD drive until your PC has completely restarted.
Now the installation of the scanner driver is completed.
ATTENTION
This screen may not appear when the
"Autoplay" setting of your PC is off. In this
case, run "Install.exe" in this CD-ROM directly
from the "Explorer" or "My Computer".
ATTENTION
When you select [Yes] for installing the Error
Recovery Guide, [Choose Setup Language]
window appears. Select a language and fol-
low the instructions on the window. Error
Recovery Guide will automatically finish fin-
ishing its installation. Please wait until the
installation of TWAIN driver automatically
starts.
ATTENTION
Depending on the OS, these operations
may be necessary.
For Windows 98:
When a request for inserting the CD-ROM
for Windows 98 appears, insert it into the
CD drive and click the [OK] button.
For Windows 2000:
When [Digital Signature not Found]
appears, click [Yes].
ATTENTION
To confirm whether the installation was
successful, perform a scanning operation
with an application that complies with the
TWAIN regulations such as ScandAll 21.