Basic operation, General, Turning the power on/off – Furuno CSH-5 MARK-2 User Manual
Page 16: Basic operating procedure, Power on
10
4. BASIC OPERATION
General
This section provides information necessary for basic operation of
the CSH-5 MARK-2, from turning the power on and off to detecting
and tracking fish schools. The basic operating procedure is shown
below.
Basic Operating Procedure
2
/
7
Lower/raise transducer.
Location for
magnetic function
card
4
Turn transmitter on.
1
/
8
Turn power ON (OFF).
6
Adjust gain.
3
Select display range.
OUTPUT
10
PL
10
TVG, (Far, Near) 5, 5
AGC
0
NOISE LIM
3
VP
1
IR
OFF
5
Set tilt angle.
CONTROL SETTINGS
Turning the Power On/Off
Power On
Press the
POWER
switch on the main panel. The lamp at the left of
the switch lights.
Note:
The Display and the Transceiver are checked for proper op-
eration each time the power is applied. The check is explained
in greater detail in a later chapter.