FUJITSU FTP-632MCL004 - Manual (Page 3)

3
FTP-632MCL001/002/303/304
Part number FTP-632MCL001/002 FTP-632MCL303/304
Interface Centronics (ESC/POS TM ), RS232C
24 VDC
±
5%, Voltage
Current : average *2 ( ): Peak
For head 1.11 (1.45) A (at 80 mm/s printing speed, 25% printing ratio)
0.81 (1.45) A (at 50 mm/s printing speed, 25% printing ratio)
0.75 (0.87) A (at 30 mm/s printing speed, 25% printing ratio)
For motor 24 VDC
±
5%, 1.0 A maximum
For cutter --- 24 VDC
±
5%, 1.0 A maximum
For logic 5 VDC
±
5%, 0.5 A maximum
Mechanism 108 (W)
×
48 (D)
×
20 (H) mm (Excluding lever) 117 (W)
×
57 (D)
×
38 (H) mm
Interface board 131 (W)
×
89 (D)
×
24 (H) mm
Weight approximately 94 g approximately 330 g
Expected life Mechanism
Pulse durability : 1
×
10 8 pulse/dot (using Fujitsu's standard driving
method)
Wear resistance : 50 km (at 25% printing ratio)
Cutter --- 500,000 cuts
Operating temperature 0 to +50
°
C *3
Operating humidity 20 to 85% RH (no condensation)
Storage temperature –20 to +60
°
C (excluding paper)
Storage humidity 5 to 95% RH (no condensation)
Head temperature By thermistor (applied energy control, abnormal temperature detection)
Detection Paper out/Mark detect By photointerrupter
Head-up By microswitch
For front insertion use (80 mm width) : FTP-030PU001, FTP-030P0701
For rear insertion use (85 mm width) : FTP-030P0020, FTP-030P0702
*Recommended papers
· Oji Paper
: PD150R, PD160R, PD170R
· NIPPON Paper : TF50KS-E,TF60KS-E,TF60KJ-R
· MITSUBISHI Paper Mills : P220VBB-1, AFP-235
Power supply
Dimensions
Specifications Item
(Continued)
Environmental
conditions
Recommended thermal sensitive paper
*1: There may be exceptions.
*2: 24 VDC, minimum head resistance.
*3: Guarantee: +5
°
C ~+40
°
C.