Fisher-Price BARBIE 78477 - Manual (Page 14)

13
• Fit the lens tabs on the back of a lens assembly into the
headlight slots in the grille.
• Press firmly to snap the lens assembly into the grille.
• Repeat this procedure to snap the other lens assembly
into the grille.
Grille
Tab
Slot
12
Brush Guard Bumper
• Fit and hold the brush guard against the front bumper.
• Insert two #10 x 1" screws through the front of the brush
guard and into the bumper.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Headlight
Lens
Wide Notch Wide Tab
Lens
Guard
Assembly
10
11
Steering Wheel
Steering
Wheel
Cap
• Fit the wide notch in the side of a headlight lens under
the wide tab on a lens guard.
• Press firmly on the inside of the headlight lens to snap it
into the lens guard.
• Repeat this procedure to assemble the other headlight
lens to the remaining lens guard.
• Fit the steering wheel cap into the center of the steering
wheel with the screw holes aligned.
• Insert two #8 x 1" screws as shown.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
14