FUJITSU MAV2036RC - Manual (Page 8)

Important Alert Items
iv C141-E219
Task Alert message Page
Installation 2. When dismounting the drive which is mounted on the
system while power is not supplied to it.
• Do not move the drive until the drive stops completely (about 15
seconds if the spindle motor was stopped by a START/STOP UNIT
command, and about 15 seconds after powering-off when the power
was simply turned off).
• Then, dismount the drive using the drive mounting/dismounting
mechanism, etc. of the system.
• When storing or transporting the drive, put it in the antistatic bag
(refer to Section 5.1).
5-10
Diagnostics
and
Maintenance Data loss
Save data stored on the disk drive to other media before requesting repair.
Fujitsu does not assume responsibility if data is destroyed during servicing
or repair. 6-5
Electreical shock
1. To avoid injury, do not touch the PCA.
2. Never use any solvents to clean the disk drive during operation
6-5
Damage
1. Always ground yourself with a wrist strap connected to ground before
handling. ESD (Electrostatics Discharge) may cause the damage to the
device.
2. Never use a conductive cleaner to clean the HDD.
3. Never remove any labels from the drive or deface them in any way.
4. Never remove the PCA.
5. Never open the disk enclosure for any reason.
6-5
Damage
1. Never remove any labels from the drive.
2. Never open the disk enclosure for any reason. Doing so will void any
warranties.
6-13