Furman Sound PF-Pro - Manual (Page 6)

power factor pro manual
t r o u B l e - s H o o t i n G G u i d e
1.) Symptom: no power to the aC outlets.
possible cause: Circuit breaker has
tripped due to excessive load.
action needed: remove one piece of
equipment from the Power factor Pro unit,
and push the square re-set tab into the circuit
breaker bezel.
2.) Symptom: no power to the aC outlets,
“Protection oK” indicator is not lit.
possible cause: either the aC outlet that
your Power factor Pro device is connected
to has no aC voltage present, or the unit has
been subjected to a sustained voltage in
excess of 400 volts.
action needed: Plug the Power factor
Pro unit into an aC receptacle where aC
voltage is present. if the problem persists, the
protection circuit may be damaged factory
service may be required.
3.) Symptom: extreme Voltage indicator lit.
possible cause: input voltage is above
135 - 140 volts, causing power to the unit’s
outlets to be shut down. additionally, if the
voltage is below 85-90 volts at turn on, the unit
will not allow aC voltage to reach the outlets.
action needed: Correct the line voltage.
then turn the unit on. Consider installing a
furman voltage regulator.
tHree Year liMited
WarrantY
furman sound, llC., having its principal place
of business at 1997 south Mcdowell Blvd.,
Petaluma, Ca 94954 (“Manufacturer”) warrants
its Pf-Pro and Pf-Pro r (the “Product”) as
follows:
Manufacturer warrants to the original
Purchaser of the Product that the Product sold
hereunder will be free from defects in material
and workmanship for a period of three years
from the date of purchase. the Purchaser
of the product is allowed fifteen days from
the date of purchase to complete warranty
registration by mail or on-line at the furman
website. if the Product does not conform to this
limited Warranty during the warranty period
(as herein above specified), Purchaser shall
notify Manufacturer in writing of the claimed
defects. if the defects are of such type and
nature as to be covered by this warranty,
Manufacturer shall authorize Purchaser to
return the Product to the furman factory
or to an authorized furman repair location.
Warranty claims should be accompanied by a
copy of the original purchase invoice showing
the purchase date; this is not necessary if the
Warranty registration was completed either via
the mailed in warranty card or on-line website
registration. shipping charges to the furman
factory or to an authorized repair location must
be prepaid by the Purchaser of the product.
Manufacturer shall, at its own expense, furnish
a replacement Product or, at Manufacturer’s
option, repair the defective Product. return
shipping charges back to Purchaser will be
paid by Manufacturer.
tHe foreGoinG is in lieu of all
otHer Warranties, eXPress or
iMPlied, inCludinG But not liMited
5