Furman Sound PF-Pro - Manual (Page 3)

power factor pro manual
harmonics, and clarity you’ve been missing!
additionally, the Power factor Pro is the most
comprehensive power conditioner ever created
for the serious musician. furman’s series
Multi-stage Protection Plus (sMP+) guards
your equipment from voltage spikes that can
damage your amplifier or other connected
equipment.
furman’s sMP+ features unparalleled
clamping voltage. While other designs offer
clamping voltages that are well above 330Vpk,
furman’s sMP+ clamps at 188Vpk (133 VaC
rMs) even when tested with multiple 6000Vpk
- 3000 amp surges! and, our pro level over-
voltage auto shutdown circuit assures you will
never see your prized amplifier go up in flames
due to a sustained voltage overload.
the Pf-Pro has a generous 12 amp r.M.s.
capacity, a convenient 20 segment aC
voltmeter, a detachable-locking aC cord,
and (4) aC outlets, all contained in a small
convenient, floor standing package. The PF-
Pro r has the same features except its cord
is not detachable and it has (8) rear outlets
and (1) front panel outlet. it also features
a BnC connector on the rear panel to allow
attachment of any standard gooseneck lamp
(such as furman’s model Gn-i or Gn-led) to
illuminate the rear of your rack.
s a f e t Y i n f o r M at i o n
to obtain best results from your furman Power
factor Pro Power Conditioner, please be sure
to read this manual carefully before using.
WA R N I N G: to reduce the risk of electrical
shock, do not expose this equipment to rain
or moisture. dangerous high voltages are
present inside the enclosure. do not remove
the covers. Refer servicing to qualified
personnel only. The lightning flash with an
arrowhead symbol, is intended to alert the user
to the presence of un-insulated dangerous
voltage within the product’s enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock.
i M P o r ta n t s a f e t Y
i n s t r u C t i o n s
(Please read prior to installation)
1. Please read and observe all safety and
operating instructions before installing
your Power factor Pro unit. retain these
instructions for future reference.
2. Your Power factor Pro unit should not be
used near water – for example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet
basement, near a swimming pool, etc.
3. do not place your Power factor Pro unit
near heat sources such as radiators, heat
registers, stoves, or other appliances that
produce heat.
4. the Power factor Pro should only be
connected to a 120 VaC, 60Hz, 15 amp (“e”
version - 220 VaC, 10 amp) grounded electrical
outlet. do not defeat the ground or change
polarization of the power plug.
5. Pay particular attention to the condition of
the cords and cables at the plugs. to prevent
risk of fire or injury, damaged cords and cables
should be replaced immediately.
2