FRIGIDAIRE 137111500B - Manual (Page 13)

13
General installation
Grounding type Grounding type
wa
wall receptacl ll receptacle
Po Power cord with wer cord with
3-prong 3-prong gr grounded plug ounded plug
Do not, Do not, under under
an any cir y circumstances, cumstances,
cut, cut, remo remove ve,
or b or bypass th ypass the
gr grounding pr ounding prong. ong.
Connect the exhaust duct to the outside exhaust system 1.
(see pages 4 through 6). Use of a 4” (10.2 cm) clamp (item
A) is recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other joints.
Carefully slide the dryer to its fi nal position. Adjust one or
2.
more of the legs until the dryer is resting solidly on all four
legs. Place a level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and discard door
tape.
Plug the power cord into a grounded outlet. 3.
Turn on the power at the circuit breaker/fuse box. 4.
Read the 5. Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
If you have any questions during initial operation, please
6.
review the “Avoid Service Checklist” in your Use & Care
Guide before calling for service.
Place these instructions in a location near the dryer for
7.
future reference.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
A wiring diagram and technical data sheet are
located inside the dryer console.
A