Fisher & Paykel DD36S - Manual (Page 3)

Important!
Be sure the edges of the services hole are smooth or covered. If the services hole is through a metal
partition the hole must be protected with the Edge protector supplied to prevent damage to the
power cord or hoses.
These marks indicate formed bracket screw locations.
Preferred position. If adequate clearance, services hole can be higher.
If hole is higher, ensure drain hose(s) are routed straight into the waste connection.
Water Connection
Recommended HOT (Maximum 140°F/60°C).
Supplied hose to suit 3/8” (9 mm) male compression fitting.
Water Pressure Max Min
Water softener models 1 MPa (145 psi) 0.1 MPa (14.5 psi)
Other models 1 MPa (145 psi) 0.03 MPa (4.3 psi)
Important!
The power outlet must be located in a cabinet adjacent to the DishDrawer cavity.
PARTS SUPPLIED 4
5 CAVITY PREPARATION
Max. distance of
hoses and cord from
chassis edge
Left hand
side
Right hand
side
Drain hose
78 ½ ”
(2000 mm)
59 1⁄16”
(1500 mm)
Inlet hose
64 ¾ ”
(1650 mm)
37 3⁄8”
(950 mm)
Power cord (excl. plug) 29 ½ ”
(750 mm)
15 ¾ ”
(400 mm)
Left hand
side
Right hand
side
*
2” x 4”
Note: Services c
an be located
either side of D
ishDrawer®.
Important!
Adjacent cabinetry must not
extend above cavity base
110-120 VAC / 7 A
min.
7 7⁄8 ”
(200 mm)
2 ½ ”
(65 mm)
3⁄8 ” (10 mm)
min. 1⁄16 ”
(2 mm)
max.
ø 1 ½ ” (38 mm)
Moisture
protection
tape must
be applied.
If no side
partition, use
a brace for
securing.
* Water supply
Clamp (1) Wire clip (1) Phillips
5⁄8 ” (16 mm)
screws (7)
1 ½ ” (38 mm)
bottom
fixing screws
& metal
washers (2)
Drain hose
support (1)
Moisture protection
tape (1)
(to prevent moisture
damage)
Drain hose
joiner (1)
Rubber
washer for
inlet hose (1)
Edge protector (1)
(if services hole
partition is metal)
If the Drain hose supplied is not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hose by 11’ 10” (3.6m).
The kit is available from the nearest Fisher & Paykel Authorized Service Agent, or Toll free 1.888.936.7872 or www.fisherpaykel.com.
Side mounting
bracket kit
(A and B) (2)
OPTIONAL
(2,1) -1- 599796A DD36S installA2 USCA.indd 19/2/10 11:32:01 AM (2,1) -1- 599796A DD36S installA2 USCA.indd 19/2/10 11:32:01 AM