Frymaster BIGLA30 - Manual (Page 24)

3-6
1. Open the cabinet and slide the JIB from
the cabinet (see Figure 4).
Figure 4
2. Remove the cap and pour any remaining oil in the
container into all fry vats equally (see Figure 5).
Figure 5
3. Place new JIB upright and remove the
cap and foil seal (see Figure 6).
Figure 6
4. Put the tube in the new full container (see Figure 7).
Figure 7
5. Slide the JIB onto the shelf inside the fryer cabinet (as
seen in Figure 4).
6. Press the JIB reset switch to turn the JIB LED on the
front of the fryer off (see Figure 8).
3.4.4 Bulk Oil Systems
Instructions for installing and using bulk oil systems are found in Appendix A located
at the rear of this manual.
WARNING: Do not add
HOT or USED oil to a JIB.
Figure 8