FUJITSU answers^2 D1740 - Manual (Page 28)

Installing and removing processors
Upgrading main memory
Technical data
Technology: DDR 200, DDR 266 or DDR 333 unbuffered DIMM modules
184-Pin; 2.5 V; 64 Bit, no ECC
Size: 128 Mbytes up to 2 Gbyte DDR-SDRAM
Granularity: 128, 256, 512 or 1024 Mbyte for one socket
A current list of the memory modules recommended for this mainboard is available on the Internet
at: www.fujitsu-siemens.com/mainboards.
At least one memory module must be installed. Memory modules with different memory capacities
can be combined.
!
You may only use unbuffered 2,5 V memory modules. Buffered memory modules are not
supported.
DDR- DIMM memory modules must meet the PC1600 (DDR 200), the PC2100 (DDR 266)
or the PC2700 (DDR 333) specification.
Installing a memory module
2
2
► Push the holders on each side of the memory slot outwards.
► Insert the memory module into the location (1).
► At the same time flip the lateral holders upwards until the memory module snaps in place (2).
18 - English A26361-D1740-Z120-1-6319, Edition: 3