Fisher-Price JEEP RUBICON H4433 - Manual (Page 11)

N1476pr-0920
11
ASSEMBLY F
N1476pr-0920
Position the windshield so that the molded detail on the
wipers faces the front of the vehicle.
Hint: The windshield will only fit one way. If it does not seem to
fit, turn it around and try again.
Insert and “snap” the two large tabs on the windshield into
the large slots in the dash.
Pull up on the windshield to be sure it is secure.
•
•
•
Insert the "T" end of a short seat belt through a slot near the
outer edge of the seat. Make sure the side of the seat belt
with the fastener faces the outer edge of the seat.
Pull up on the short seat belt to be sure it's secure in the slot.
Repeat this procedure to assemble the other short seat belt.
Insert each fastener end of the long seat belt strap through
the slots in the center of the seat. Make sure the fasteners
face the outer edge of the seat. Pull each side of the long seat
belt strap evenly through the slots until each T-loop is pulled
through the slot. •
•
•
•
13
With the seat at an angle, insert the two tabs on the front edge of
the seat into the slots in the foot-well wall
A .
Push down firmly on the edge of the seat above each tab to snap
the tabs into the slots
B .
Rotate the back of the seat down C to snap the seat tabs into
the slots in the vehicle. Push down firmly on the seat back.
•
•
•
B
C
A
B
TOP VIEW
11
12
Insert a #10 x ¾" screw into the rear edge of the seat and tighten. •
14 BACK VIEW
Wipers Wipers
Windshield Windshield
Large Tab Large Tab
Large Tab Large Tab
Large Slots Large Slots
Short Seat Belts Short Seat Belts
Fastener Fastener
Side Side
Seat Seat
Seat Back Seat Back
Tabs
Tabs Tabs Tabs
Fastener Fastener
Side Side
Long Seat Belt Long Seat Belt
Fastener Sides Fastener Sides