FUJITSU fi-5120C - Manual (Page 4)

ii
INTRODUCTION
Thank you for purchasing the fi-5120C/fi-5220C
Duplex Color Scanner product.
This document describes how to handle fi-5120C/fi-
5220C Duplex Color and basic operation methods.
Before you start using fi-5120C/fi-5220C Duplex Color
be sure to thoroughly read this manual to ensure correct
use.
The "Operator’s Guide" is stored on the Setup Disk.
The guide provides useful and detailed information on
Operations when you would like to using advanced fea-
tures, daily maintenance of the scanner, replacement of
consumables.Please also read the Operator’s Guide for
your reference.
■ Regulatory Information
FCC Declaration
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
located.
• Consult your dealer or an experienced radio/TV
technician.
FCC warning: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
Canadian DOC Regulations
This digital apparatus does not exceed the Class B
limit for radio noise emissions from digital
apparatus set out in the Radio interference
Regulations of the Canadian Department of
Communications.
This Class B digital apparatus complies with
Canadian ICES-003.
Le pésent appareil numérique n’ément pas de
parasites radioélectriques dépassant les limites
applicables aux appareils numériques de la classe
B, limites prescridtes dans le Réglement pour le
brouillage radioélectrique qui fut dicté par le
Ministere des Communications du Canada.
Cet appareil numérique de la classe B est
conformme à la norme NMB-003 du Canada.
Bescheimigung des Herstellers /
Importeurs
Für den fi-5120C/fi-5220C2 wid folgendes
bescheinigt:
• In Übereinsstimmung mit den Bestimmungen
der EN45014(CE) funkentstört
• Maschinenlärminformationsverordnung
3.GPSGV, 06.01.2004: Der höchste
Schalldruckpegel beträgt 70 dB (A) oder
weniger, gemäß EN ISO 7779.
International E NERGY S TAR
® Program
As an
E
NERGY
S
TAR
®
Partner, PFU LIMITED has
determined that this product
meets the
E
NERGY
S
TAR
®
guidelines for energy efficiency.
The International
E
NERGY
S
TAR
®
Office
Equipment Program is an international program
that promotes energy saving through the
penetration of energy efficient computers and
other office equipment. The program backs the
development and dissemination of products with
functions that effectively reduce energy
consumption. It is an open system in which
business proprietors can participate voluntarily.
The targeted products are office equipment such
as computers, monitors, printers, facsimiles,
copiers, scanners, and multifunction devices.
Their standards and logos (
) are uniform
among participating nations.
ATTENTION
The use of a shielded interface cable is
required to comply with the Class B limits
of Part 15 of FCC rules.
The length of the AC cable must be 2
meters (6.6 feet) or less.