Furuno FELCOM 16 - Manual (Page 100)

4. INMARSAT C OPERATIONS
4-6
13. Press the [Enter] key to open the confirmation window.
14. To request notification of delivery from the LES, choose ON. If not necessary
choose OFF.
15. Press the [Enter] key to close the window.
16. Press the [
↓] key to choose Send Delay.
17. Press the [Enter] key to open the send delay entry window.
18. To send a message after a certain delay, enter a time up to 99 hours 59
minutes. (The Send Delay is used to time message arrival to suit recipient’s
office hours.)
19. Press the [Enter] key to close the window.
20. Press the [
↓] key to choose Delivery Delay.
21. Press the [Enter] key to open the delivery delay options window.
22. Delivery Delay requests the LES for “Immediate” or “Deferred” transmission
to the recipient designated. Press the [ ↑] or [ ↓] key to choose Immediate or
Deferred. For information on this service, consult with LES where message is
to be sent.
23. Press the [Enter] key to close the window.
24. Press the [
↓] key to choose Code and press the [Enter] key.
25. Press the [
↑] or [ ↓] key to choose “IA5 (for e-mail, fax) ”, “ITA2 (for telex)”,
“DATA” or “SMS” as appropriate.
26. Press the [Enter] key to close the window.
27. Press the [
↓] key to place the cursor on TRANSMIT.
28. Press the [Enter] key to open the start window.
Date
Time
Position
Waypoint
Course
Speed
Current NCS
Current Channel
Current TDM
MES Status
GPS Status
DCE Memory
97-08-04
01:32 (UTC)
LAT
LON
LAT
LON
DEG
KTS
344 (IOR) LOGOUT
NCS CC
NCS CC
Idle
****
32818 Bytes free
BBER
C/N
Send level
RxIF AGC Level
REF Offset Freq
Synthe 1st local
3rd local
Synthesizer
TX2nd Local
Antenna Power Supply
Water Temperature
Water Current
Direction
Speed
Depth
Transmit Message
Normal
SEISETU.TXT Size 46
FURUNO Cost ********.** (US$)
TELEX
81
321
303 (KDDI) Start
No Yes ON
00:00
Immediate
IA5
Priority
Message File
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
Attach File
LES ID
Option
Confirmation
Send Delay
Delivery Delay
Code
[ TRANSMIT ]
Transmit message screen
29. Press the [Enter] key to send the message to the message queue. (To
escape, choose “No” and press the [Enter] key.) The message “Message is
entered in sending Queue. Press any key.” appears.
Note 1: If some data has not been entered, the message “Input Error: xx.”
(xx: error content) appears.
Note 2: When you send a message which contains more than 32 KB of data,
the message “Message file is too large (but sent only with 32 KB).”
appears. The message is sent with only 32KB of data.