Fujitsu Siemens Computers C Series - Manual (Page 18)

C Serie
10 A26391-K110-Z100-1-7619
No display appears on screen, power-on indicator flashes
If no display appears on the screen and the power-on indicator flashes, this may have the
following causes:
The screen power-management feature may be active.
Ê Press any key to activate the display.
The notebook is in Standby or Suspend mode.
Ê Press the Suspend/Resume button to end the Standby or Suspend mode.
The display angle or brightness may not be properly adjusted.
Ê Change the display angle and set the brightness by pressing the key [Fn] together with the key
[F6] (darker) or [F7] (brighter) until the picture appears correct.
The notebook is set so that the picture only appears on the external screen.
Ê Press the key combination [Fn] + [F10] to switch over the display to the LCD screen or to
specify the simultaneous display on the LCD screen and the external screen.
The notebook switches off
You have defined a time limit in the "Power" menu in BIOS Setup that is insufficient for your
needs.
To run the BIOS Setup you must reboot your notebook.
Ê Press the Suspend/Resume button to reboot the notebook.
Ê When the text Diagnostic screen Boot Menu BIOS Setup
appears, press the [F2] key immediately.
Ê Correct the time limit in the Power menu in the BIOS Setup .
If you are operating the notebook with a battery, you may have overlooked the reference to
the low battery level and the notebook has switched over to Standby mode.
Ê Connect the power adapter.
Ê Press the Suspend/Resume button.