Fisher-Price 76970 - Manual (Page 13)

• Align the hole in a wire retainer with the screw peg
directly below the steering column. Make sure the ends
of the wire retainer face the rear of the vehicle.
• Insert a #8 x 1 /
2
" (blunt) screw through the wire retainer
and into the screwpeg.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Align the hole in the remaining wire retainer with the
screw peg directly below the main wire connector.
• Insert a #8 x 1 /
2
" (blunt) screw through the wire retainer
and into the screwpeg.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
Screw Peg
Main Wire
Connector
13
Assembly
14 15
Wire
Retainer
• Place the loose wires between the ends of the wire
retainer below the steering column.
• Twist the ends of the wire retainer together to hold the
wires against the vehicle body.
• Place the wiring between the ends of the wire retainer
below the main wire harness connector.
• Twist the ends of the wire retainer together to hold the
wiring against the vehicle body.
Steering Column