Assembly – Fisher-Price JEEP 74526 User Manual

Page 13

Assembly

Microphone

Dash

• Bend the plastic tip on the end of the microphone cord so

that it forms a “T”.

• Fit the “T” end of the microphone cord down through

the hole in the dash pocket. Pull up gently on the
microphone cord to make sure the end is secured in
the dash.

• To hang the microphone on the dash, fit the hook on the

back of the microphone onto the notch in the dash.

• Before applying labels to the dash, wipe the dash with a

clean dry cloth to make sure it is free of dirt and oils.
Make sure your hands are clean and dry.

• Apply labels as shown in the illustration. For best results,

avoid repositioning a label once it has been applied.

PLAY

STOP

REV

FWD

PAUSE

COMPACT DISC

TREB

BASS

COOL

HEAT

CAUTION

This vehicle was
designed to
carry 130 lbs.
or less.
Overloading
may cause
extensive
damage to
motors, gears
and tires.

9 2 7 6

Dash View

Battery Tips:

• Do not mix old and new batteries.

• Do not mix different types of batteries: alkaline, standard

(carbon-zinc) or rechargeable (nickel-cadmium).

• Remove the batteries during long periods of non-use.

Always remove exhausted batteries from the sound box.
Battery leakage and corrosion can damage the vehicle.

• Never short circuit the battery terminals.

• Non-rechargeable batteries are not to be recharged.

• Only batteries of the same or equivalent type as

recommended in these instructions are to be used.

• If removable rechargeable batteries are used, they are

only to be charged under adult supervision.

• Rechargeable batteries are to be removed from the

sound box before they are charged.

• If you use a battery charger, it should be examined

regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.

• When sound from the vehicle becomes faint, or if the

sound stops working, it’s time to replace the batteries.

• Dispose of batteries safely.

• Loosen the screw in the sound box’s battery

compartment door using a Phillips screwdriver and open
the battery compartment.

• Insert three, size “AA” (LR6) alkaline batteries in the

sound box as indicated in the battery compartment.

• Close the battery compartment door and tighten the

screw using a Phillips screwdriver. Do not over-tighten.
(For longest life, use only alkaline batteries.)

Sound Box

Battery
Compartment

Battery
Compartment
Door

SHOWN ACTUAL SIZE

3 x 1.5V

“AA” (LR6)