Meridian Audio 568 - Manual (Page 99)

92
Configuring the digital surround processor using a computer
● If you have two Meridian source units of the same type you
can configure them to have different Comms addresses. You
can then select the appropriate source by specifying its
Comms address in the Comms address field.
The following additional options are available. You should only
change these with advice from your dealer:
Option Description
30ms delay for audio Avoids the noise caused by
sources to avoid DTS noise switching to a DTS audio
(DTS delay) source.
Only ever play DTS for this Creates a video DTS source
source that will avoid any DTS noise
when switching audio formats.
Number of frames of delay Adds a delay required by
to apply to audio certain video systems.
Poor digital audio source – Select this if you have difficulty
frequency out of range locking to the source.
Source uses validity flag May reduce switching noise
properly on certain sources where this
is a problem.
To set the advanced source options
● Click the Advanced tab to show the Advanced page of
settings.
● If the source is connected to another Meridian unit, set
Comms type to 1C for a Meridian CD player, 2C for a
Meridian FM tuner, and 3C for a Meridian DVD player.
Otherwise set it to none.