Furuno AUTOPILOT NAVPILOT-500 - Manual (Page 32)

3. STEERING MODES
3-16
3.5 REMOTE Mode
Four types of optional remote controllers may be connected to the NAVpilot-500.
These are used to operate the Navpilot-500 from a remote location.
Dial type remote controller (FAP-5551, 5552)
This remote controller can only be used when in the STBY, AUTO or NAV mode.
1. Turn on the remote controller switch to show “FU” (Follow-Up) on the control
unit. If the remote controller switch is turned on when in the STBY mode, a
beep sounds to alert you that remote mode is not available.
FU
359
359.9
FU mode
(Follow-Up)
Heading from
heading sensor
Rudder angle
Course set
HDG
M
RUDDER
0
40 20 10 40 20 10
Heading mode
M: Magnetic
T: True
Turning power on FU (Follow-Up) mode display
(dial type) (dial remote controller)