Furuno AUTOPILOT NAVPILOT-500 - Manual (Page 13)

2. BASIC OPERATION
2-3
2.3 Adjusting Brilliance and Contrast
The brilliance and contrast can be adjusted as below:
1. Momentarily press the [POWER/BRILL] key. The CONTRAST and BRILL
window appears.
CONTRAST
BRILL
10
8
PORT STBD
Contrast, brilliance window
2. Rotate the course control knob to adjust display contrast; clockwise to raise
the contrast and counter-clockwise to lower it. (16 levels are available.)
The contrast can also be adjusted by pressing the [POWER/BRILL] key.
3. Press the [PORT] or [STBD] key to adjust display brilliance, [PORT] to lower
the brilliance and [STBD] to raise it. (Eight levels are available.)
To close the CONTRAST and BRILL window, press any key except the
[POWER/BRILL], [STBD] or [PORT] key.
2.4 Displays
2.4.1 Choosing the display mode
There are four types of displays: Normal display 1 (page 1), Normal display 2
(page 2), Data display (page 3) and Graphic display (page 4).
To choose a display mode, press a mode key (AUTO, NAV or STBY). Each time
a mode key is pressed the display changes in the sequence shown below.
HDG
(Mode) (Course)
(Heading)
(Data) P S
Heading mode
HDG
(Mode)
(Course)
(Heading)
Heading mode
(Data1)
(Data 2)
P S (Data)
(Normal display 1)
HDG
(Graphic)
Heading mode
(Mode)
(Course)
(Graphic display)
HDG HDG (Mode)
(Course)
(Heading)
Heading mode
(Data1)
(Data 2)
(Data display)
(Normal display 2)
Analog indicator
[1]
Page No.
[2]
[3] [4]
Displays