Fisher & Paykel E411T - Manual (Page 14)

12
Installation instructions (all models)
4. Installation
Your Fisher & Paykel Active Smart™ refrigerator is fitted
with front and rear rollers, designed for moving the
product in the forwards and backwards direction.
Avoid moving the product in a sideways direction as this
may damage the rollers or the floor covering/surface.
A
Your refrigerator will arrive with the front feet wound
up making moving the product into its final location a
simple task.
B
Roll the refrigerator into its final position making sure
there is the correct air gap between the product and
surrounding cabinetry. See minimum clearance in
cabinetry dimensions table (refer to page 7).
(RF540A model only)
C
Adjust the front feet down until the refrigerator is leaning
backward with the front approximately 10 mm higher
than the back. This will ensure a good door closing
action. (Refer to Fig.10).
D
Aligning your refrigerator with cabinetry.
■ ■
Align the sides of the refrigerator with the cabinetry by
adjusting the hinge side front foot.
■ ■
Adjust the handle side foot until it touches the floor and
takes a small amount of weight.
■ ■
Once the refrigerator is in place and aligned with
cupboards/alcove push gently on the front top and check
if the product is rocking or stable.
■ ■
5. Levelling of refrigerator door
(RF540A model only)
■ ■
For uneven surfaces, front feet can be used to align the
2 doors.
■ ■
If left hand door is too low, then unscrew the left hand
foot to lift up the cabinet until the two doors top edges
are aligned.
■ ■
If right hand door is higher, then adjust the right hand
foot in the same way.
Raise the
front of the
refrigerator
Lower the front
of the refrigerator
Fig.10 Refrigerator feet
Fig.11 Uneven door alignment
Fig.12 Even door alignment