Installation instructions (ice & water only), Installation instructions – Fisher & Paykel E411T User Manual
Page 11
9
Installation instructions (Ice & Water only)
Installation instructions:
1
Ensure the refrigerator is not plugged into a power supply.
2
Locate isolation tap for water connection – cold water feed
only (dishwasher or sink mixer taps). Tee and tap fitting is
not supplied.
3
Connect the 200 mm (8”) blue tubing to the outlet of the
PRV (blue collet) and the inlet connection of the water filter
cartridge as shown in Diagram 1. Gently pull on both ends
to ensure it is locked.
4
Connect the white 6 mm (¼”) tubing to the outlet of the
water filter cartridge as shown in Diagram 2. Gently pull to
ensure it is locked.
5
Measure the required length of tubing to run from the PRV
to the water connection point.
6
Cut the tubing making sure the ends are square and clean.
7
Connect the tubing to the tap connection and the base
of the PRV (white collet) and then to the tap as shown in
Diagram 3. Please note that the tap connection supplied
should fit most installation situations.
8
Connect one locking key to each side of the water filter
cartridge in between the cartridge and the locking collet
as shown in Diagram 4.
9
To flush the water filter of any trapped air, harmless
carbon fines and to also check for leaks, aim the end of
the tubing into a bucket, turn isolating tap on and run at
least 10 litres (10 qt) of water through. Once complete,
turn isolating tap off.
10
Locate desired position for water filter noting carefully
the following points:
■
■
It is recommended to fit the water filter in a vertical
orientation with the water filter head at the top. This will
minimise water leakage when replacing cartridge.
■
■
Ensure the filter is in a convenient location to access every
6 months for replacement. We suggest that this location is
beside the water filter supply tap in the cupboard beside
the refrigerator.
■
■
A minimum clearance of 64 mm (2 ½”) from the bottom of
the filter cartridge is required to perform cartridge removal.
■
■
Do not screw water filter to the refrigerator.
INLE
T
Diagram 4
Fig.6 Locking key
Diagram 3
Fig.5 Tap connection
Fig.3 PRV connection
Diagram 1
Diagram 2
Fig.4 Waterline connection