Furuno FR-2155 - Manual (Page 56)

4-14
10.Fasten the front panel of the display pedestal.
11. Fasten the ground wire to the location shown in Figure 4-14.
12.Close the monitor.
4.4 Performance Monitor PM-30
Necessary parts: PM-30 and OP03-150 (Code no. 008-485-490)
e m a N e p y T y t Q . o N e d o C
d r a o B M P 5 2 2 9 P 3 0 1 0 2 6 - 7 8 4 - 8 0 0
w e r c S d a e H n a P W 0 0 7 2 C 8 x 3 M 3 4 0 4 - 1 8 8 - 0 0 0
. y s s A r o t c e n n o C A A - 0 0 3 L - P 3 H V 2 4 1 0 - 1 4 1 - 0 0 0
1. Lift the monitor. See Chapter 1 for instructions.
2. Fasten the PM Board 03P9225 to the location shown below with three screws
(M3 x 8).
J401
J411
PM Board
03P9225
Figure 4-15 Display unit, inside view
3. Connect the connector P401 coming from J411 to J401 on the PM Board.
4. Connect two connector assemblies (VH3P-L300-AA) to J402 and J403.
5. Solder the other end of there connector assemblies with external cables, one
from ship’s mains and one from the PM-30.
6. Close the monitor.