FUNAI CR270TT8 - Manual (Page 16)

16
EN
O
PTIONAL SETTING
Channel Add/Delete
The channel add/delete function lets you add the channel that was not
added by the auto channel scan due to the reception status at the initial
setting. You can also delete the unnecessary channels.
1
Press [MENU] to display the main menu.
MENU
2
Use [CH K/L] to select “CHANNEL SET”, then press
[VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
PICTURE
CHANNEL SET
[ENG]/ESP/FRA
V-CHIP SET UP
CAPTION [OFF]
DTV SET UP
3
Use [CH K/L] to select “ADD/DELETE(DTV)” or “ADD/
DELETE”, then press [VOL X].
e.g.) digital TV mode
or
CH
CH
VOL
ADD/DELETE(DTV)
AUTO PRESET CH(DTV)
AUTO PRESET CH(TV/DTV)
AUTO PRESET CH(CATV)
! CATV takes approx. 50min.
4
Select the channel you want to add or delete.
(Refer to “Channel Selection“ on page 12.)
e.g.) digital TV mode
D12
ADD/DELETE:DTV
5
Use [VOL X/Y] to select “ADD” or “DELETE”.
• To add or delete another channels, repeat steps 4 - 5 .
or VOL VOL
• Color of channel number displayed at the right top of
the TV screen indicates;
- Blue: The selected channel will be added.
- Red: The selected channel will be deleted.
5
6
Press [MENU] to exit.
MENU
Note:
• The main menu will disappear automatically in about 10
seconds.
• In the digital mode (DTV), you can add or delete channels
only for major channel.
• Once you delete a DTV channel, you cannot recover the
channel without performing auto channel scan again.
(Refer to “Auto Channel Scan” on page 11.)
L4758UJ_EN.indd 16 L4758UJ_EN.indd 16 2006/12/11 22:06:59 2006/12/11 22:06:59