FUJITSU PRIMERGY ECONEL30 - Manual (Page 8)

System configurator and order-information guide
C PRIMERGY Econel30 Status 2003-10-28
Section VII SCSI Controller
There are 7 slots (max. 340 mm): 1x AGP (ocuppied by AGP graphics card), 6x PCI long
A. SCSI Controller for backup drives
S26361-F2644-E3
SCSI Controller UW SCSI Controllers only for backup drives
with LSI Chip 53C1000R In SCSI Basic Units not necessary
1 channel LVD,
for internal backup drive
max. 160MB/s; with cable
64/66 PCI, min 166mm,
PCI standard profile
int: HD68 LVD, ext:
SW:
max. 1x per system
B. SCSI Controller for external peripheral devices
S26361-F2399-E1
SCSI 160 Controller
Adaptec SCSI Card 29160
1 channel: LVD + Fast/ Ultra (decoupl.)
LVD connect. for HD, without cable
Fast/Ultra connect. for acc. drives
64/66 (32/33) PCI, min 180 mm, hp
int: Fast 50 pins or Ultra HD68
+ LVD HD68; ext: HD68(LVD)
SW:
max. 1 per system
Section VIII Disk array
S26361-F2567-E2 In RAID-modus you need 2 IDE RAID Controller for the connection
IDE RAID Controller of 4 hard disk drives!
Promise Fasttrak 100 LP
2-channel IDE RAID Controller
max. 100MB/s, with cable A second IDE RAID Controller can only later be ordered as -L part number.
1 HD per channel max. It may be mounted only after installation of the operating system.
32/66 PCI, min. 180mm
int.: 2 x ATA 100 UDMA
ext.:
SW:
max. 1x per system
D
IDE RAID Controller are only released for
IDE Basic Units!
Fujitsu Siemens Computers
Enterprise Products - PRIMERGY Server 8 of 11