FUJITSU PRIMERGY ECONEL30 User Manual
Page 3
System configurator and order-information guide
PRIMERGY Econel30 Status 2003-10-28
Configuration diagram for "PRIMERGY Econel30" system unit
SIDE VIEW
FRONT VIEW
System unit ( I )
Pentium 4 / Celeron
Standard
Power supply
Processor ( II )
Memory ( III )
5.25"x1.6" DVD
Extension slots
5.25"x1.6"
Graphics ( IV )
SCSI Controller ( VII )
Disk array
Communication/Network ( IX )
5.25"x1.6"
Miscellaneous ( X )
3.5"x1" Floppy disk
AGP short
Accessible drives (V)
PCI 32-Bit / 33MHz, long
Hard disks ( VI )
PCI 32-Bit / 33MHz, long
IDE/SCSI - 3.5"x1"
PCI 32-Bit / 33MHz, long
IDE/SCSI - 3.5"x1"
PCI 32-Bit / 33MHz, long
IDE/SCSI - 3.5"x1"
PCI 32-Bit / 33MHz, long
IDE/SCSI - 3.5"x1"
PCI 32-Bit / 33MHz, long
Recommendation of HD extension
Number of HDs
4
No 1
No 2
No 3
1)*
No 4
1)*
onb. = onboard
MA = Master
Ch = Channel
SL = Slave
All needed cables are enclosed.
Depending on the number and type of HDs, the chart above shows the connection of HDs
to the on-board IDE Controller, to the IDE RAID cards and to the SCSI controller card respectively.
1) * A second RAID Controller can only later be ordered as -L part number.
onb. MA
1.RAID MA Ch2
ID 1 (opt.)
2.RAID MA Ch1
ID 2 (opt.)
onb. MA
onb. MA
RAID MA Ch1
-
-
-
-
-
MIXED
IDE
MIXED
IDE
Standard
IDE
onb. MA
Standard
IDE
or
RAID
IDE
RAID MA Ch1
RAID MA Ch1
HD-Bays
-
-
onb. SL
RAID MA Ch2
-
onb. SL
RAID MA Ch2
RAID MA Ch2
2.RAID MA Ch2
ID 3 (opt.)
1
2
1-4
3
Bank 1
Bank 2
2
1
4
3
PCI-Bus
1
2
3
4
6
5
or
RAID
IDE
SCSI
1.RAID MA Ch1
ID 0 (std.)
Fujitsu Siemens Computers
Enterprise Products - PRIMERGY Server
3 of 11