Two fortiswitch boards per chassis – Fortinet 5003 User Manual
Page 69
FortiGate-5140 and 5050 base backplane communication
Base backplane HA configurations
FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
01-30000-85717-20081205
69
It makes no difference which FortiSwitch-5003A base front panel interfaces you
use to link the base channels. You can connect an Ethernet cable, either straight-
through or crossover, from any base front panel interface on one
FortiSwitch-5003A board to any base front panel interface on another
FortiSwitch-5003A board installed in the other chassis. You can also use the base
front panel interfaces to connect more than two chassis together. The same
applies to the FortiSwitch-5003 ZRE0, ZRE1, or ZRE2 interfaces and to
connections between FortiSwitch-5003A and FortiSwitch-5003 boards.
Default heartbeat interfaces vary by the model of the FortiGate boards, and are
not always base backplane interfaces. For example, FortiGate-5005FA2 boards
use fabric1 and fabric2, the fabric backplane rather than the base backplane, as
the default heartbeat interfaces. To send heartbeat communications through the
base backplane, you must enable and configure the priority of base1 and base2
as heartbeat interfaces.
Figure 23: FortiGate-5140 HA cluster with two available base backplane heartbeat
interfaces (through FortiSwitch-5003A boards in hub/switch slots 1 and 2)
Two FortiSwitch boards per chassis
Installing two FortiSwitch-5003 boards provides two base backplane HA heartbeat
channels and two configuration options:
• Configure heartbeat interface failover to maintain communications through the
base backplane. For example, if you have a FortiGate-5001A cluster, you
could configure the cluster to use base1 as the primary heartbeat interface,
and base2 as a backup if base1 fails.
FA N T R AY
FA N T R AY
FA N T R AY
13
11
9
7
5
3
1
2
4
6
8
10
12
14
5140
CR
ITIC
AL
RES
ET
MA
JOR
MIN
OR
USE
R1
USE
R2
USE
R3
5140SAP
SERIAL 1
SERIAL 2
ALARM
FILTER
1 2
0
1
2
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0 ETH1
10/100
5000SM
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0 ETH1
10/100
5000SM
Base channel 1
Base channel 2