Fabric gigabit switching within a chassis – Fortinet 5003 User Manual
Page 48
FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
48
01-30000-85717-20081205
Fabric gigabit switching within a chassis
FortiGate-5050 fabric backplane communication
This section describes:
•
Fabric gigabit switching within a chassis
•
Fabric channel connections between FortiSwitch-5003A boards
•
Fabric gigabit switching between chassis
•
Fabric gigabit switching to the network
•
Fabric 10-gigabit switching within a chassis
•
Fabric channel layer-2 link aggregation
•
Fabric channel layer-2 link aggregation and redundancy
•
Example active-passive redundant link configuration
•
Example active-active redundant link configuration
Fabric gigabit switching within a chassis
You can use FortiSwitch-5003A fabric channel switching for communication
between the fabric backplane interfaces of FortiGate-5001A or 5005FA2 boards
installed in a FortiGate-5050 chassis.
shows a FortiGate-5050 chassis with a FortiSwitch-5003A board in
hub/switch slot 2, and FortiGate-5001A boards in slots 3, 4, and 5. In this
configuration the FortiSwitch-5003A board provides 1-gigabit fabric backplane
switching for the FortiGate-5001A fabric2 interfaces. The FortiSwitch-5003A
boards operate as layer-2 switches and the FortiGate-5001A boards operate as
typical standalone FortiGate units.
The chassis can be connected to the network using any of the FortiGate-5001A
front panel interfaces. You can also connect FortiSwitch-5003A front panel fabric
interfaces to the network. You can also install FortiGate AMC modules in the
FortiGate-5001A boards and connect the network to the AMC front panel
interfaces. The AMC modules and the network connections are not shown in
.
Figure 16: FortiGate-5050 fabric channel 2 data communication
1
2
2
3
4
5
SMC
1
SMC
POWER
5050SAP
SERIAL
1
SERIAL
2
ALARM
10/100
link/Act
ETH0 Service
RESET
ST
ATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
10/100
link/Act
ETH0 Service
RESET
ST
ATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
Fabric channel 2
data communication