Hitachi 42PMA500 - Manual (Page 41)

39
ENGLISH
Selected characters Setup hint
Audio Input
AV1 Stereo L/Mono
This should correspond to the audio signal from the equipment that is
connected to AV1 audio input terminal. If it is monaural audio, set this to
L/Mono.
AV2
(Same to AV1) AV3
AV4
Scart Output Not Available (grayed out)
RGB1 DVI-PC DVI-STB
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB1 DVI terminal.
RGB2 (1st step) RGB Component
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
RGB2 (2nd step) Auto HDTV SDTV/DVD
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
Approximately 1 sec. after adjustment is completed, the adjustments will be recorded as shown in the table below.
OTHER FEATURES
Automatic Store
Menu Display Registration condition
Picture Picture Mode 1 setting is registered.
Contrast For every input function and every
Picture Mode, 1 setting is
registered.
Brightness
Colour
Sharpness
Hue
Colour Temperature
Contrast Mode
YNR
CNR
Film Mode
PAL Comb Filter
LTI
CTI
Black Enhancement
Auto Colour
Colour Temp. Adjust
R Amplitude For every Colour Temperature, 1
setting is registered.
G Amplitude
B Amplitude
R Cut Off
G Cut Off
B Cut Off
Colour Management
For every input function and every
Picture Mode, 1 setting is
registered.
Magenta 1 setting is registered.
Red
Menu Display Registration condition
Picture Yellow 1 setting is registered.
Green
Cyan
Blue
Colour Decoding -
Red For every Colour Temperature, 1
setting is registered. Green
Colour For every input function and every
Picture Mode, 1 setting is
registered.
Hue
Function Video Power Save 1 setting is registered.
Default Zoom
Setup System 1 setting is registered.
Colour System 1 setting is registered.
AV1
AV2
AV3
AV4
Video Input -
AV1 1 setting is registered.
AV2
AV4
Audio Input -
AV1 1 setting is registered.
AV2
AV3
AV4
RGB1
RGB2
• The previously recorded items will be lost.
▼
▼