Hitachi 42PMA500 - Manual (Page 34)

32
OPERATING INSTRUCTIONS
Input Switching
AV1 AV2
RGB 1 RGB 2
AV3
MUTE VOL
VOL
AV4
AUTO PinP
OK
SIZE RECALL
MENU
• Input can be switched by pressing the AV1, AV2, AV3,
AV4, RGB1 or RGB2 buttons of the remote control.
• Input can be switched in the sequence of AV1 ➔AV2 ➔
AV3 ➔ AV4 ➔ RGB1 ➔ RGB2 by pressing the INPUT
SELECT button of the monitor.
AV1 AV2 AV3
RGB2 RGB1 AV4
INPUT SELECT button
RGB/VIDEO
buttons
SIZE button
Each time the SIZE button of the remote control or the
monitor is pressed, the screen display size will change in
sequence and the status will be displayed at the bottom
of the screen.
Full
Size Switching
• During VIDEO signal input (AV1, AV2, AV3)
• The size will fix as Full mode and not change when receiving the
component signal of 1080i/50, 1080i/60 or 720p/60.
Panoramic 4:3 Full
14:9Zoom C14:9L Zoom
Display size selection diagram
When you want to Set the display size to Input signal Display screen Remarks
Play a 4:3 image in a 16:9 screen faithfully. 4 : 3 Blanking occurs on both sides.
Play a 4:3 image in a 16:9 screen with the
height and width of the middle of the
screen enlarged on equal scales and with
both sides appearing somewhat enlarged.
Panoramic
Play a 16:9 VISTA size image in the 4:3
image faithfully reproduced on the 16:9
screen.
Zoom
• The 4:3 image is called a letterbox image.
• In some cases, some slight blanking may
remain at the top and bottom.
Play a 4:3 image faithfully in a 16:9 screen
in the standard vertical size and
horizontally squeezed.*
Full
* An image with an aspect ratio of 16:9
shrunk horizontally to 4:3 to display in a 4:3
screen
Play a 14:9 image in a 16:9 screen
expanded vertically and squeezed
horizontally.
C14 : 9L
This mode is provided for the broadcasting
program with WSS code-C14:9L.
Play a 14:9 image expanded vertically on
the 16:9 screen.
14 : 9Zoom
This mode is provided for the broadcasting
program with WSS code-14:9Zoom.
(4:3 signal)
(Squeeze)
(Vista)
SIZE button
• During AV4 signal input
• [Auto] is the mode using the Switch signal from the equipment
connected to AV4 terminal included in SCART connector No.8 pin
which indicate the picture format of the video source. When Switch
signal has not been detected, Default Zoom setting in the Function
Menu is used to choose.
• And during some input mode except AV4, if the Switch signal is
detected under the condition that [Auto] is selected for the picture
size of AV4, the input mode will automatically transfer to AV4.
Auto Full Zoom
14:9Zoom C14:9L
(14:9 signal)
(14:9 signal)