HP ML115 - Manual (Page 23)

System Unit System Unit System Unit System Unit Dimensions Dimensions Dimensions Dimensions (HxWxD)
(with feet) 14.46 x 6.88 x 16.76 in (36.7 x 17.5 x 42.6 cm)
Weight Weight Weight Weight (approximate) 23.15 lb (10.5 kg)
Input Requirements Input Requirements Input Requirements Input Requirements
(per power supply) Range Input Voltage 100 to 127 VAC/200 to 240 VAC
Normal Line Voltage 115 or 230 VAC
Line Frequency Line Frequency Line Frequency Line Frequency 50 to 60 Hz
Rated Input Current Rated Input Current Rated Input Current Rated Input Current load 8A at 115VAC, 4A at 230VAC
BTU Rating BTU Rating BTU Rating BTU Rating 1907 BTU
SCSI Connectors SCSI Connectors SCSI Connectors SCSI Connectors
(SCSI Models only) One internal LVD/SE connector for U160 devices, plus two internal SE
connectors for legacy devices.
Power Supply Output Power Supply Output Power Supply Output Power Supply Output
Power
Power Power Power (per power supply)
Rated Steady-State Power 370W
Maximum Peak Power 370W
Temperature Range Temperature Range Temperature Range Temperature Range Operating 50° to 95° F (10° to 35° C)
Shipping -31° to 140° F (-35° to 60° C)
Relative Humidity Relative Humidity Relative Humidity Relative Humidity
(non-condensing) Operating 10% to 90%
Non-operating 10% to 95%
Acoustic Noise Acoustic Noise Acoustic Noise Acoustic Noise Idle
(Fixed Disk Drives
Spinning)
LLLL WAd (BELS) 5.4
LLLL pAm (dBA) 36
Operating
(Random Seeks to Fixed
Disks)
LLLL WAd (BELS) 5.9
L pAm (dBA) 38
HP 160GB 1.5G SATA HP 160GB 1.5G SATA HP 160GB 1.5G SATA HP 160GB 1.5G SATA
7.2K NHP 3.5" HDD
7.2K NHP 3.5" HDD 7.2K NHP 3.5" HDD 7.2K NHP 3.5" HDD
411275-B21
160GB 7,200 rpm 160GB 7,200 rpm 160GB 7,200 rpm 160GB 7,200 rpm Capacity Capacity Capacity Capacity 160,041 MB
Height Height Height Height 1.0 in. (26.1 mm)
Width Width Width Width 4.0 in. (101.6 mm)
Interface Interface Interface Interface Serial ATA
Transfer rate Transfer rate Transfer rate Transfer rate synchronous synchronous synchronous synchronous
(maximum)
1.5 Gb/s
Seek time Seek time Seek time Seek time (typical reads,
including settling) Single track 0.9 ms
Average 9.0 ms
Full-stroke 17.8 ms
Rotational speed 7,200 rpm
Physical Configuration Physical Configuration Physical Configuration Physical Configuration Bytes/Sector 512
Logical Blocks 312,581,808
Operating Temperature Operating Temperature Operating Temperature Operating Temperature 41° to 131° F (5° to 55° C)
QuickSpecs
HP ProLiant ML115 HP ProLiant ML115 HP ProLiant ML115 HP ProLiant ML115
Technical Specifications
DA - 12704 Worldwide — Version 16 — May 12, 2008 Page 23