Hunter 21978 54 1912 Mission Manual - Manual (Page 9)

9
41225-01 • 12/04/09 • Hunter Fan Company
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
4-1. Unbundle the wires from the fan.
For Standard or Angled mounting:
4-2. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy. Feed the wires from the fan
through the downrod.
4-3. Loosen the square head setscrew on the adapter to install the
downrod. Note: When the downrod is fully installed, 2-3 threads
on the pipe will still be visible; this is normal. Securely retighten
the setscrew with a wrench or pliers. Skip to Step 5-7.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer.
4-4. Remove the setscrew from the adapter.
4-5. Place the low profile washer (lip down) into the canopy. Be sure
the green ground wire is pointing up toward the ceiling.
4-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
4-7. Raise the fan and place the hook on the ceiling plate through the
round hole in the rim.
Steps 4-4 – 4-5
Low Profile Screw
Low Profile Washer
Steps 4-1 – 4-2
Downrod
Canopy
Step 4-6
Round
Hole
Setscrew
4 • Assembling and Hanging the Fan