Hunter 21978 54 1912 Mission Manual - Manual (Page 14)

14
41225-01 • 12/04/09 • Hunter Fan Company
3 • Assembling tbe Blades
8 • Aligning the Fixture Fitter (Continued)
8-6. Plug the upper and lower plug connectors together. The connectors
are keyed and will only go together one way. Before assembling
the light fixture to the fixture fitter locate the arrow shaped hole
positioned directly behind one of the (3) screw clearance holes on
the outside flange of the light fixture.
8-7. Align the arrow in the light fixture with the arrows previously used to
align the fan trim and fixture fitter.
8-8. Attach the light fixture to the fixture fitter using (3) 3/8” long
Phillipsa round head screws with lock washers. Tighten the screws
securely.
8-9. Install (2) candelabra base bulbs. Refer to
maximum wattage label on light fixture for
maximum lamp wattage.
Fixture
Trim
Light
Fixture
Fixture
Fitter
Note: In compliance with U.S. Federal energy regulations, this ceiling fan contains a wattage saver that restricts
the light kit to a maximum of 190 Watts. Exceeding that limit or the specifications on the light sockets
may result in fire hazard or improper operation. If lights do not appear to be operating properly, see the
troubleshooting section
Step 8-6-8-8
Step 8-9