Hobie SPORT CRUISER 21 User Manual
Page 9
7
8.4 Lace the wing tramp as shown. (FIGURE 10)
8.6 Before sailing, secure the wing legs on the
hull with a short piece of line. (FIGURE 12)
NOTE: INSTALL WING TRAMPS SO
LACE LINES DO NOT INTERFERE WITH
CUP HOLDERS (FIGURE 11)
WARNING:
WINGS WILL NOT FLOAT!
CAUTION
It is very important that the wings are
completely inserted when sailing or
whenever any load is applied to them.
Failure to completely insert the wings will
result in hull and/or wing damage. You
have inserted the wings completely when
the band of tape on the outboard side of
each insertion tube aligns with the top of
the hull deck.
8.5 To insert the wings, simply work the leg
tubes into the hull sockets an inch or so at a
time. Push one leg of the wing into the tube,
then the other and continue alternating until
both sides are completely inserted. If the wings
cannot be easily inserted using this system,
check the end caps and sockets for debris
(such as sand), improper fitting or metal burrs.
FIGURE 10
FIGURE 11
FIGURE 12