Hobie SPORT CRUISER 21 User Manual
Page 19
20.1 Attach the main sheet system as shown.
Tie off the traveler line end (B) with a figure-
eight knot. (FIGURE 37)
20.MAINSHEET ATTACHMENT
20.2 Move and secure the traveller car to the
left side of the boat. Using the mainsheet,
sheet in tight. Now tighten the left shroud by
moving it down two or three holes in the
adjuster. Secure the shroud with a clevis pin
and ring. (FIGURE 38)
20.3 Release the tension on the mainsheet
and move the traveller to the right side. Repeat
to tighten the right shroud.
20.4 Release the tension on the mainsheet
when the tightening procedure is finished and
return the boom to its normal position.
NOTE: Whenever the boat is set up,
tightening will be required to achieve proper
shroud tension.
19.BOOM INSTALLATION
Push gooseneck pin through mast and fasten
main furling handle with clevis pin and ring.
(FIGURE 36)
Attach topping lift wire to outboard end of
boom.
FIGURE 38
FIGURE 37
FIGURE 36
17