Hobie SPORT CRUISER 21 - Manual (Page 8)

6
8. WINGS
8.1 Identify the left and right wing assemblies.
Red Dot = LEFT
Green Dot = RIGHT
8.2 Mark the legs with tape as shown. These
points indicate full and complete insertion of
the legs into the hull. (FIGURE 8)
8.3 Put the right wing legs into the sockets and
place the right seat onto the legs. All parts are
pre-drilled so the holes should line up properly.
Rivet the seat onto the legs using rivets and
rivet caps. (FIGURE 9)
FIGURE 8
FIGURE 9
7. CAT CABIN
(FRONT TRAMPOLINE MUST BE LOOSE) POSITION BOX OVER FRONT CROSSBAR. EASE
DOWN OVER CROSSBAR. STUDS IN THE BOTTOM OF CAT CABIN PASS THRU THE
TRAMPOLINE SLOTS. REMOVE TWO BLACK PLATES, FOUR BLACK LOCK KNOBS AND LOCK
WASHERS FROM RIG KIT. PLATES INSTALL SO THAT THE CABIN IS REMOVABLE FROM
BELOW THE BOAT BY HAND.
FIGURE 7