Hitachi 51SWX20B - Manual (Page 57)

SETUP
57
Select ANTENNA if you are using an indoor or outdoor antenna. Select Cable if you have cable TV.
Use THUMB STICK ̇ , ̈ to highlight the correct signal mode.
Press down on THUMB STICK to select highlighted signal.
Press EXIT to quit MENU or select ANT A to return to previous menu.
Reception channels for each mode are shown at the left.
Refer to your cable or TV guide for channel identification standards.
Set The Channels
THUMB
STICK
SELECT
Set The Channels
Set The Clock
Menu Preference
Setup
Set The Inputs
Move SEL Select
Set Event Timer
Set Closed Captions
Setup
Move SEL Return
Set The Channels
Ant A
Ant B
THUMB
STICK
Setup
Move SEL Select
Set The Channels
Setup
Move SEL Return
Set The Channels
Ant A
Source
Antenna
Cable(1) Cable(2)
Auto Channel Scan Start
THUMB
STICK
SELECT
THUMB
STICK
Setup
Move SEL Select
Set The Channels
Ant A
Source
Antenna
Cable(1) Cable(2)
Auto Channel Scan Start
Ant A
Ant B
About Your TV
RECEPTION BAND
CATV 1 OR CATV 2
AIR
VHF 2 ~ 13ch
UHF 14 ~ 69ch
CATV CHANNEL
VHF 2~13
Mid band A~1
A-5 ~ A-1
Super band J~W
Hyper band
W + 1 ~ W + 28
Ultraband
W + 29 ~ W + 84
Indicated on
the screen
2 ~ 13
14 ~ 22
95 ~ 99
23 ~ 36
37 ~ 64
65 ~ 125
NOTE: If certain CATV channels are poor or not possible in Cable (1) mode, select Cable (2).