beautypg.com

A/v network setup wizard, There are six steps in this procedure – Hitachi 51SWX20B User Manual

Page 19

background image

19

A/V NETWORK SETUP WIZARD

There are six steps in this procedure.

HITACHI AV NET Wizard (step 1 of 6)

This Wizard helps you with

VCR connections and settings.

Would you like to setup or

modify your VCR?

BACK

NEXT

HITACHI AV NET Wizard (step 2 of 6)

Follow the digrams shown in Hitachi’s

Easy Graphic Guide

to connect your VCR.

Carefully position the IR “mouse” in front

of your VCR as shown in the diagrams.

BACK

NEXT

HITACHI AV NET Wizard (step 3 of 6)

Find your VCR

4-digit manufacturers code

and enter it here - - - -

(Enter Code “9999” to uninstall)

BACK

NEXT

If Error

ATTENTION

The 4-digit code did not match
AV Net’s library. Please check

and re-enter a valid code

- - - -

BACK

NEXT

Proper Code Entered

from page 20.

HITACHI AV NET Wizard (step 4a of 6)

Which TV Rear Panel Input
is connected to your VCR?

(

b

) ANT A

( ) INPUT 3

( ) ANT B

( ) INPUT 4

( ) INPUT 1

( ) INPUT 5

( ) INPUT 2

BACK

NEXT

HITACHI AV NET Wizard (step 4b of 6)

Which RF channel does your VCR

use to send video to the TV?

(

b

) Channel 03

( ) Channel 04

BACK

NEXT

HITACHI AV NET Wizard (step 5 of 6)

Turn ON your VCR then press

each of the 3 function keys below.

Your VCR should respond to one of these

keys. Now press NEXT to continue.

BACK

NEXT

POWER

PLAY

CH UP

HITACHI AV NET Wizard (step 6 of 6)

Did your VCR respond to

POWER, PLAY or CH UP?

Press DONE to finish this wizard or

HELP to trouble shoot settings.

HELP

DONE

HITACHI AV NET Wizard

Congratulations!

Your VCR is now conected

to your AV network.

TROUBLE SHOOTING

Please check connections shown

in the EASY GRAPHIC GUIDE.

If connections are correct,

try a different manufacturers code

for your VCR

0 4 3 6

BACK

NEXT

HITACHI AV NET Wizard (step 3b of 6)

This will uninstall VCR

on INPUT 1.

Would you like to proceed?

BACK

YES

ANT A/B

DONE

HELP

From Step 3, once you enter “9999”,
the following message appears.

4.

Press the A/V NET button on the remote control. The A/V Network Setup Wizard will automatically start upon the very first use.
You can access the Setup Menu Wizard again in the future by pressing the A/V net button and selecting SETUP.

5.

Follow the steps below to setup your A/V network (See page 20 for A/V Network Codes).

6.

Enter “9999” to uninstall the equipment from your A/V Network.

7.

See Remote Control A/V NET button usage on page 24.

NOTES:

1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre-

coded into the A/V Net.

2. In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please

consult your equipment receiver operating guide.